Connecting Wires To Terminals - Kenwood DNX890HD Quick Start Manual

Quick Start Guide

Connecting wires to terminals

Ignition key
switch
Car fuse box
(Main fuse)
Battery
To use the steering wheel remote
control feature, you need an exclusive
remote adapter (not supplied) matched
Connect to the terminal that is
grounded when either the telephone
rings or during conversation.
To use the Mute feature, you need to
hook up this wire to your telephone by
using a commercial telephone accessory.
Depending on what antenna you are
using, connect either to the control
terminal of the motor antenna, or to the
power terminal for the booster amplifier
When using the optional power amplifier,
connect to its power control terminal.
Fuse (10A)
ACC
Red (Ignition wire)
Yellow (Battery wire)
Car fuse box
Black (Ground wire)
(To car chassis)
A
A
Light Blue/Yellow
(Steering remote control wire)
To steering remote
to your car.
To car light control switch
of the film-type antenna.
(Max. 300mA, 12V)
If no connections are made,
do not let the cable come out from the tab.
Accessory 1
STEERING WHEEL
REMOTE CONT
REMOTE INPUT
Orange/White
(Dimmer control wire)
ILLUMI
Brown (Mute control wire)
MUTE
Blue
(Antenna control wire)
ANT CONT
Blue/White
(Power control wire)
P. CONT
28
Fuse (10A)
White/Black
To front left
speaker
+
White
Gray/Black
To front right
speaker
+
Gray
Green/Black
To rear left
speaker
+
Green
Purple/Black
To rear right
speaker
+
Purple
Speaker impedance: 4-8 Ω