Connecting Wires To Terminals - Kenwood Specifications Quick Start Manual

Quick Start Guide

Connecting wires to terminals

Pin Numbers for
ISO Connectors
External Power
Connector
A-4
A-5
A-6
A-7
A-8
Speaker Connector
B-1
B-2
B-3
B-4
B-5
B-6
B-7
B-8
*Speaker Impedance: 4-8 Ω
2 WARNING for Connecting the ISO Conncetor
The pin arrangement for the ISO connectors depends on the type of vehicle you drive. Make
sure to make the proper connections to prevent damage to the unit. The default connection
for the wiring harness is described in (1) below. If the ISO connector pins are set as described
in (2), make the connection as illustrated. Please be sure to reconnect the cable as shown (2)
below to install this unit to the Volkswagen vehicles etc.
(1): Default setting
The red (A-7 pin) of the vehicle's ISO
connector is linked with the ignition, and
the yellow (A-4 pin) is connected to the
constant power supply.
Red (Ignition cable)
Yellow (Battery cable) Yellow (A-4 pin)
Accessory 1
Cable Color Functions
Yellow Battery
Blue/White Power Control
Orange/White Dimmer
Red Ignition (ACC)
Black Earth (Ground)
Connection
Purple Rear Right (+)
Purple/Black Rear Right (–)
Gray Front Right (+)
Gray/Black Front Right (–)
White Front Left (+)
White/Black Front Left (–)
Green Rear Left (+)
Green/Black Rear Left (–)
Red (A-7 pin)
Unit Vehicle
Fuse (10A)
A: Black
(Ground wire)
B: Yellow
(Battery wire)
C: Red
(Ignition wire)
A B C
If no connections are made, do not let the
wire come out from the tab.
Blue/White (Power
control/ Antenna
Connect either to the power control
control wire)
terminal when using the optional
ANT.
power amplifier, or to the power
P.CONT
CONT
terminal for the booster amplifier
of the film-type or short pole type
Brown (Mute
antenna.
control wire)
Connect to the terminal that is
MUTE
grounded when either the telephone
rings or during conversation.
Light Blue/Yellow
(Steering remote
control wire)
To use the steering wheel remote
STEERING WHEEL
control feature, an exclusive remote
REMOTE CONT
REMOTE INPUT
adapter (not supplied) that matches
your car is required.
(2)
The red (A-7 pin) of the vehicle's ISO
connector is connected to the constant
power supply, and the yellow (A-4 pin) is
linked to the ignition.
Red (Ignition cable)
Unit
Yellow (Battery cable)
26
8 6 4 2
7 5 3 1
8 6 4 2
7 5 3 1
Red (A-7 pin)
Vehicle
Yellow (A-4 pin)