Storing And Handling Paper - Xerox 4110 User Manual

Storing and Handling Paper

X e r o x 4 11 0 / 4 5 9 0 U s e r G u i d e
KEY POINT: Printing with paper that is a different type or size
from the paper selected by the printer driver, or printing
from an unsupported paper tray can result in paper jams.
To ensure correct printing, select the correct paper size,
paper type, and paper tray.
NOTE: GSM is a measure of the substance of paper expressed in
grams per square meter.
Ream weight is the weight of a 788
consisting of 1,000 sheets.
When copying with a non-standard paper size from Tray 5
(Bypass), you must manually enter the paper size. In
addition, if you use a non-standard paper size often, you
can preset the size in the device. Then the preset size
appears under Standard Sizes in the Tray 5 (Bypass)
screen. For information about setup, refer to "Tray 5
(Bypass) - Paper Size Defaults" in the System
Administration Guide.
! Please keep the following points in mind when storing paper
• Store paper inside a cabinet or other dry place. Paper that
has absorbed moisture can cause paper jams and image
quality defects.
• After opening a package of paper, wrap up the remaining
paper to store it. It is recommended that you include
moisture prevention packets.
• Paper should be stored flat, to prevent bends or warping.
! Please adhere to the following when setting paper into the
tray
• Align the stack of paper neatly before setting it in the tray.
• Do not use paper that is folded, creased, or heavily
warped.
• Do not use waved or curled paper.
• Do not load paper of mixed size together into the tray.
• Transparency paper and label paper can cause paper
jams, and multiple sheets can be fed to the printer at once.
Be sure to carefully fan these types of paper.
• When continuously outputting onto transparencies,
transparency sheets sometimes will stick to each other.
Remove transparencies from the output tray every 20 or so
sheets, and fan them to cool them down.
8 . P a p e r a n d O th e r M e d i a
1,091 mm ream
×
8-3