Toshiba TOSVERT VF-AS1 Instruction Manual page 95

Adjustment level
(a)
(b)
(c)
(d)
Note: The 100% value of input/output power is the product of • ã 3×200V (400V) × inverter's rated current.
[Example: Procedure of calibrating the meter connected to the terminal AM to which "output current" is assigned.]
Key operated LED display
–
MODE
ENT
ENT
ENT
ENT
ENT
ENT
MODE
Fixed output 1
( ) • •
185%
150%
250%
Displays the operation frequency. (Perform during operation stopped.)
(When standard monitor display selection
The first basic parameter "History function (
Press either the
Pressing the ENTER key allows the reading of parameter setting.
Set the parameter at
the key.
⇔
Press the ENTER key to save the change. Then,
are displayed alternately.
Select the AM terminal meter adjustment
Press the ENTER key to switch to the data display mode.
Press either the
Adjust the pointer to the graduation to which you want it to point when the
inverter passes a current 100% larger than its rated output current.
(The meter reading will change at this time but be careful because there
will be no change in the inverter's indication).
By setup, before the needle of meter beings to sway, it will take time.
Press the ENTER key to save the change. Then
⇔
displayed alternately.
Select the "AM terminal meter adjustment
Pressing the ENTER key allows the reading of parameter setting.
Return the parameter setting to
Press the ENTER key to save the change. Then,
⇔
are displayed alternately.
Press the MODE key three times to return to the running frequency display
mode. (When standard monitor display selection
frequency])
E-29
Meter adjustment
Fixed output 2
( ) • •
54%
100%
81%
135%
Operation
)" is displayed.
or key to select " . "
(fixed output for meter calibration 2) by pressing
by pressing the
key or the key to adjust the meter.
[Hint]
It's easier to make the
adjustment if you push and
hold for several seconds.
" by pressing the
(output current display).
E6581301
Fixed output 3
( ) • •
40%
74%
60%
100%
= [Output frequency])
and the set value
key.
and the set value are
key.
and the set value
= [Output
5