Monitoring The Status; Status Monitor Under Normal Conditions - Toshiba TOSVERT VF-AS1 Instruction Manual

8.2

Monitoring the status

8.2.1 Status monitor under normal conditions

In this mode, you can monitor the operation status of the inverter.
To monitor the inverter when it is normally running, press the • @ • @ • @
on the LED display.
Setting procedure (EX.: operation at 60 Hz)
Commun
ication
No.
*1
-
FE01
FE01
*2
-
*3
-
*4 -
*5
-
*6
-
8
*7
-
-
*8
*9
-
FE06
[Note 4]
FE07
FE08
FE73
(Continued overleaf)
Key
Item displayed
operated
Standard monitor
mode
Setting monitor
MODE
mode
Status monitor mode
MODE
(Rotating direction)
Frequency
command value
Output current
Input voltage (DC
detection)
Output voltage
Torque
Regenerative
braking resistance
overload factor
(PBrOL data)
Inverter overload
factor
(OL1 data)
Motor overload
factor
Input terminal
information 1
Input terminal
information 2
Input terminal
information 3
Output terminal
information 1
Output terminal
information 2
CPU1 version
CPU2 version
twice
key
MODE
LED
display
The operation frequency is displayed (during operation).
(When standard monitor display selection
to [Output frequency])
The first basic parameter "History function (
displayed.
The rotating direction is displayed. ( :Forward run,
:Reverse run)
The operation frequency command value is displayed.
(When = , Frequency command)
The inverter output current (load current) is displayed.
(When = , Output current)
The Inverter DC voltage (default setting:unit %) is
displayed.(When
The inverter output voltage (default setting:unit %) is
displayed.(When
The torque is displayed.
(When = torque)
The regenerative braking resistance overload factor is
displayed.
(When =
overload factor)
The inverter overload factor is displayed.
(When =
The motor overload factor (default setting:unit %) is
displayed.
(When =
The ON/OFF status of each of the control signal input
terminals (F, R, ST, RES, S1, S2, S3, RR/S4) is
displayed in bits.
The ON/OFF status of each of the optional control signal
input terminals (LI1, LI2, LI3, LI4) is displayed in bits.
The ON/OFF status of each of the optional control signal
input terminals (LI5, LI6, LI7, LI8) is displayed in bits.
The ON/OFF status of each of the control signal output
terminals (OUT1, OUT2, FL) is displayed in bits.
The ON/OFF status of each of the optional control signal
output terminals (OUT3, OUT4, R1, OUT5, OUT6, R2,
R3, R4) is displayed in bits.
The version of the CPU1 is displayed.
The version of the CPU2 is displayed.
H-2
E6581301
and the current status is indicated
Description
)" is
= , Input voltage) [Note 3]
= , output voltage)
, regenerative braking resistance
, inverter overload factor)
, Motor overload factor)
is set