Toshiba TOSVERT VF-AS1 Instruction Manual page 122

Setting of switching terminals
The V/f1, V/f2, V/f3 and V/f4 switching function is not yet assigned to any terminal. Therefore, it is necessary to
assign them to unused terminals.
Ex.) Assigning the V/f switching 1 function to S1 and the V/f switching 2 function to S2.
Title
S1-CC
6
OFF
ON
OFF
ON
Select V/f1 when using the vector control and the V/f-5 point setting.
Selecting V/f2,.V/f3, or V/f4 disables vector control but enables the V/f constant control.
By using "My function," torque limits and acceleration/deceleration modes can be switched along with V/f
switching.
Note:With the operation panel or communication, the acceleration/deceleration switching (
* This function is active only in operation panel operation mode.
Function
Input terminal function selection 5 (S1)
Input terminal function selection 6 (S2)
S1: V/f switching 1
S2: V/f switching 2
S2-CC V/f
Base frequency 1
Base frequency
OFF ‚ P voltage 1
Manual torque boost 1 :
Thermal protection 1 :
Base frequency 2
Base frequency
OFF ‚ Q voltage 2
Manual torque boost 2 :
Thermal protection 2 :
Base frequency 3
Base frequency
ON ‚ R voltage 3
Manual torque boost 3 :
Thermal protection 3 :
Base frequency 4
Base frequency
ON ‚ S voltage 4
Manual torque boost 4 :
Thermal protection 4 :
F-10
Adjustment range
~
~
‚ l
CC
Parameters selected
:
:
:
:
:
:
:
:
E6581301
Example of setting
(V/f switching 1)
(V/f switching 2)
) can be set.