Paper Misfeed; Original Size Not Selected Automatically. (When The Rspf Is Installed.) - Sharp AR-5520N Operation Manual

Problem

Paper misfeed.

Original size not selected
automatically.
(When the RSPF is installed.)
Cause and solution
Misfeed occurs.
→ To remove the misfeed, see "MISFEED REMOVAL".
The paper is outside of the specified size and weight
range.
→ Use copy paper within the specified range.
Paper curled or damp.
→ Do not use curled or crimped paper. Replace with dry copy paper.
During periods when the machine is not used for a long time,
remove the paper from the tray and store it in a dark place in a
bag to prevent moisture absorption.
Paper is not loaded properly.
→ Make sure the paper is properly installed.
Pieces of paper inside machine.
→ Remove all pieces of misfed paper.
Too much paper is loaded in the tray.
→ If the stack of paper is higher than the indicator line on the tray,
remove some of the paper and reload so that the stack does not
exceed the line.
The guides on the bypass tray do not match the width of
the paper.
→ Adjust the guides to match the width of the paper.
The bypass tray extension is not pulled out.
→ When loading a large size of paper, pull out the extension.
The bypass paper feed roller is dirty.
→ Clean the roller.
A5 paper is loaded in lower paper tray or in the 250-sheet
or 2 x 250-sheet paper feed unit.
→ A5 size paper must be loaded in upper paper tray or the bypass
tray.
Original(s) curled.
→ The original size cannot be correctly detected if the original is
curled or folded. Straighten the original.
The machine is directly exposed to sunlight.
→ Install in a location that is not exposed to sunlight.
TROUBLESHOOTING
Page
91
9
–
10
91
10
11
11
102
9, 10
6
–
–
79