Manual Ratio Selection - Sharp AR-5520N Operation Manual

COPY FUNCTIONS
4
Press the [AUTO IMAGE] key (
• If the ORIGINAL SIZE indicator blinks,
Note
change the orientation of the placed original.
• If the copy is made when a PRESET RATIO
selector indicator is blinking, the copied
image may run off the page.

MANUAL RATIO SELECTION

Copies can be reduced down to 25% or enlarged up to 400%. The [PRESET RATIO] selector keys (
be pressed to quickly select a ratio from among eight preset ratios. In addition, the [Zoom] keys (
pressed to select the ratio in increments of 1%.
1
Place the original(s) in the document
feeder tray or on the document glass.
2
If the original is placed on the document
glass, select the original size.
After placing the original, be sure to close the
Note
document cover/RSPF. If left open, parts
outside of the original will be copied black,
causing excessive use of toner.
3
Use the [PRESET RATIO] selector
keys ( , ) and [Zoom] keys (
) to select the desired copy ratio.
20
).
AUTO %
The AUTO IMAGE
indicator ( ) lights
AUTO %
up and the appropriate
ratio for the original size
and paper size is
selected. (The indicator
of the selected ratio will
light up.)
(p.15)
,
Selecting a preset ratio
Press the [PRESET
RATIO] selector key
( ) to move up
through the preset ratios.
Press the [PRESET
RATIO] selector key
( ) to move down
through the preset ratios.
Fine adjustment of the
ratio
Any ratio from 25% to
400% can be set in
increments of 1%.
5
Set the number of copies and other
copy settings, and then press the
[START] key (
The copy will be delivered to the paper output
tray.
To cancel automatic ratio selection, press the
Note
[AUTO IMAGE] key (
Press a [PRESET RATIO] selector key (
to set the approximate ratio, then press the [Zoom]
keys ( or ) to increase or decrease the ratio.
To decrease or increase the zoom ratio rapidly, hold
down the [Zoom] keys (
When a [Zoom] key (
ZOOM indicator will light up and the zoom ratio will
appear in the display for about two seconds.
• To verify a zoom setting without changing
Note
the zoom ratio, Hold down the [Copy ratio
display] key (
released, the display will return to the
number of copies display.
• If the copy is made when a PRESET RATIO
selector indicator or the ZOOM indicator is
blinking, the copied image may run off the
page. To ensure that the image fits on the
page, lower the copy ratio until the indicator
stops blinking and lights steadily.
• If the PAPER SIZE indicator is not lit, there
is no appropriate paper. Load appropriate
paper in a paper tray.
4
Set the number of copies and other
copy settings, and then press the
[START] key (
The copy will be delivered to the paper output
tray.
To return the ratio to 100%, press the
Note
[PRESET RATIO] selector key (
until the 100% indicator lights up.
).
) again.
AUTO %
, ) can
, ) can be
or
or ).
or ) is pressed, the
). When the key is
(p.10)
).
or
)
)