Sharp AR-5520N Operation Manual page 72

USER SETTINGS
Program
Program name
number
7 Rotation copy
Auto paper select
8
*2
mode
9 Auto tray switching
10 to 15 Auditing mode
Erase width
16
adjustment
17 Layout in 2 IN 1 copy
18 Layout in 4 IN 1 copy
Image rotation in
20
duplex copying
Location of the
21
*1
margin
22 Margin width
Resolution in Auto/Text
23
mode
1
RSPF
* When the is installed.
2
* When there are two or more paper trays.
70
Setting codes
(factory default setting
appears in bold)
0: OFF
1: ON
0: OFF
1: ON
0: OFF
*2
1: ON
–
1: 0 mm
2: 5 mm
3: 10 mm
4: 15 mm
5: 20 mm
1: Pattern 1
2: Pattern 2
1: Pattern 1
2: Pattern 2
3: Pattern 3
4: Pattern 4
0: OFF
1: ON
1: Left edge
2: Top edge
1: 0 mm
2: 5 mm
3: 10 mm
4: 15 mm
5: 20 mm
1: 300 dpi
2: 600 dpi
Explanation
• When the auto paper select function is
enabled and there is no paper that is the same
size as the original and loaded in the same
orientation, this function will automatically
select paper of the same size that is loaded in
the opposite orientation, and rotate the image
90 degrees so that it is copied on the paper in
the correct orientation.
• When the auto ratio select function is
operating and the original and paper are
loaded in opposite orientations, this function
rotates the image so that it is copied on the
paper in the correct orientation.
• This function automatically selects paper that
is the same size as the original placed in the
RSPF, or the same size as that selected with
the [ORIGINAL] key (
be disabled.
• If the paper runs out during printing and there
is paper of the same size and orientation in
another tray, this function automatically
switches to that tray (excluding the bypass
tray). The function can be disabled.
See "AUDITING MODE SETTINGS"
• Use this setting to set the width of erasure of
shadows that appear around the edges and at
the binding margin when a book or similar
original is copied.
• Use this setting to select the layout pattern
when two original pages are copied onto a
single sheet of paper (see page
layout patterns).
• Use this setting to select the layout pattern
when four original pages are copied onto a
single sheet of paper (see page
layout patterns).
• When a one-sided vertical (portrait) original is
placed in a horizontal orientation (B4 or A3
size) for two-sided copying, the top and bottom
of the images on the front and back of the
paper will be opposite to each other.
• Use this setting to switch between the margin
at the top edge and the margin at the left edge.
• Use this setting to set the margin width.
• This setting is used to change the copy
resolution in AUTO and TEXT mode from 600
x 300 dpi to 600 x 600 dpi (high-quality mode).
Scanning is slower when high-quality mode is
used.
). The function can
(p.73).
32 for the
32 for the