Setting Input Signals; Reset (Factory Settings); When Using 2 Or More Panasonic Products (Stereo System, Amplifier, Etc.) - Panasonic SC-HTR200 Operating Instructions Manual

Setting input
signals
With "AUTO" setting,
you can playback
most of the sources.
However, if you
cannot playback
PCM or DTS sources
properly, fix the
setting accordingly.
Set to "AUTO" again
if noise occurs.
Reset
(factory settings)
The operation
settings for the unit
will be initialised to
the settings made at
the time of shipment.

When using 2 or more Panasonic products (stereo system, amplifier, etc.)

Other Panasonic products may also be operated by this unit's remote control. If this occurs, change this unit's remote
control code to "REMOTE 2". Do the following to set the remote control code and this unit's remote control mode to
the same one.
Setting the amplifier's mode (by remote control)
Press and hold for about 2 seconds.
1.
Press to select "REMOTE".
2.
REAL C.,
TV DELAY, DRCOMP, ATTENUATOR, REMOTE,
INPUT MODE, RESET, EXIT
Press to select "2".
3.
Remote control setting
While pressing , press and hold
4.
• After step 4, press [BALANCE/RETURN] a few times to display "EXIT", and then press [OK] to exit from setup mode.
To restore the code to "1"
In step 3, select "1".
In step 4, while pressing [OK], press and hold [TV] for about 2 seconds.
 Only appears when audio adjustment can be made.
Press and hold
1
to select "INPUT
Press
2
REAL C.,
MODE".
TV DELAY, DRCOMP, ATTENUATOR, REMOTE,
INPUT MODE, RESET, EXIT
Press to select setting.
3
Press to select input signal.
4
AUTO: The unit automatically detects whether input is digital
or analogue. (HDMI takes priority when input is digital.); ANLG:
Analogue input fixed; DIG: Digital input fixed; PCM: PCM (from
CDs) digital input fixed; DTS: DTS digital input fixed
 Repeat steps 3 and 4 to change setting
Press a few times to select "EXIT".
5
• Return to previous menu/cancel.
1 Press and hold
to select "RESET".
2 Press
REAL C.,
TV DELAY, DRCOMP, ATTENUATOR,
REMOTE, INPUT MODE, RESET, EXIT
to select "YES".
3 Press
All the settings are reset when you select "YES" and the input selector automatically
•
switches to "BD/DVD".
If you select "NO", you will return to step 2. To exit setup mode, press [BALANCE/
•
RETURN] a few times to display "EXIT", and then press [OK].
BASS, TREBLE, SLEEP, HDMI,
 
about 2 seconds.
for about 2 seconds.
BASS, TREBLE, SLEEP, HDMI,
 
TV, DVD, AUX1, AUX2
Press
for about 2 seconds.
BASS, TREBLE, SLEEP, HDMI,
 
YES, NO
Press
Select "EXIT" and confirm
•
to finish the setup mode.
Press
Factory setting: 1
1, 2
Press to confirm.
• Select "EXIT" and
confirm to finish the
setup mode.
Press to confirm.
Press to confirm.
Factory setting: AUTO
Press to confirm.
Press to confirm.
Select "EXIT" and
•
confirm to finish the
setup mode.
Press to confirm.
to confirm.
to confirm.
29
RQTV0311