Ac Mains Supply Connection; Checking Speaker Output - Panasonic SC-HTR200 Operating Instructions Manual

AC mains supply connection

Connect AC mains lead after all other cables are connected.
For the United Kingdom
READ THE CAUTION FOR AC MAINS LEAD ON PAGE 4 BEFORE CONNECTION
Amplifier
The cooling fan operates at high power output levels only.
Conserving power
This unit consumes a small amount of power, even when it is in standby mode (approx. 0.8 W). To save
power when the unit is not to be used for a long time, unplug it from the household mains socket. You will
need to reset some memory items after plugging in this unit.
Insertion of connector
Even when the connector is perfectly inserted, depending on the
type of inlet used, the front part of the connector may jut out as
shown in the drawing. However there is no problem using the unit.
Standby indicator
Standby/on switch

Checking speaker output

Standby/on switch [8]
Press to switch the unit from on to standby mode or vice
versa. In standby mode, the unit is still consuming a small
amount of power.
Standby indicator [^]
When the unit is connected to the AC mains supply, this
indicator lights up in standby mode and goes out when the
unit is turned on.
You can check audio output with a test signal.
1. Press to turn on the unit.
2. Press to output the test signal.
• Press to adjust the volume to the normal listening level.
• Test signal is output from one speaker at a time for two seconds in the following
order.
L (Front left) → C (Center) → R (Front right) → SUBW (Subwoofer)
If you feel the output of the center speaker and subwoofer are not
balanced with front speakers
Adjust the speaker output according to your preference. ( page 26)
3. Press to stop the test signal.
AC mains lead (included)
Household
AC mains
socket
Note
• The included AC mains
lead is for use with this unit
only. Do not use it with other
equipment.
• Also, do not use AC mains
lead for other equipment
with this unit.
Appliance inlet
Connector
Approx. 6 mm
Speaker
19
RQTV0311