Connecting Stb Etc; Setting For Automatically Switching The Input Source To Stb - Panasonic SC-HTX5 Operating Instructions Manual

HDMI cable notes
• It is recommended that you use Panasonic's HDMI cables.
• Please use High Speed HDMI Cables that have the HDMI logo (as shown on the cover).
• When outputting 1080p signal, please use the HDMI cables 5.0 meters or less.
Enjoying only with TV speaker
• When image equipment such as TV and Blu-ray Disc player/DVD recorder etc. is connected to HDMI terminal (➜ pages 10, 11, 13) of this
system, images/audio signals from the Blu-ray Disc player/DVD recorder, etc. go through this system and are transmitted to TV even if this
system is turned off using the standby/on button of this system. (Standby through function) This is convenient to enjoy only with TV speaker.
• Images recorded with x.v.Colour or Deep Colour (➜ page 25) are also supported.
Note
• When you turn this system off using the standby/on button of this system, the audio/video signals from equipment connected to HDMI
input are output through the television, even if you have set input on this system to anything other than HDMI input ("BD/DVD " or
"AUX 1 ") before turning off this system. (The selector returns to the previous setting when you turn this system on again.)
• When equipment is connected to both BD/DVD IN terminal and AUX1 terminal, images/audio signals of equipment whose input is
lastly selected are output.

Connecting STB etc.

Use this connection to enjoy STB multi-channel sources on this system.
TV
HDMI input
Make sure to connect
to TV OUT .

Setting for automatically switching the input source to STB

When you make the above connection and you use Panasonic TV (VIERA), you can automatically switch this system's input by
switching the input source of TV (VIERA) to STB in the following procedure.
Preparation: Make sure that this system has been turned on. (➜ page 16)
To return to the previous
display/To cancel during
setting operation in steps 2 to
5: Press [ RETURN].
Note
• "STB AUDIO " in step 3 is displayed only when the unit is connected to the Panasonic TV (VIERA).
Also, this is not displayed when the step 1 operation is not performed.
• If you change the connection after setting, select "OFF " once and "SET " again.
• Select "EXIT " and press [OK] to fi nish the setup mode in step 3.
Digital audio out (optical)
L
OPTICAL 1
TV
DIGITAL IN
R
UX 4
TV OUT
N
1. Switch the input source of TV (VIERA) with the above connection
and show STB pictures.
2. Press and hold [–SETUP, OFF] for about 2 seconds.
The setting items are displayed. (➜ page 21)
3. Press [w][q] to select "STB AUDIO " and press [OK].
4. Press [e][r] to select "SET " and press [OK].
SET : The setting is automatically switched to "AUX2 / STB ".
OFF : The setting is not automatically switched to "AUX2 / STB ". (factory setting)
5. Press [ RETURN] several times to select "EXIT " and press [OK]
to fi nish the setting.
• Turn off all equipment before making any connections.
• To connect equipment, refer to the appropriate operating
instructions.
HDMI IN
HDMI
Amplifi er
cable
OPTICAL 2 COAXIAL
AUX 2 AUX 3
BD/DVD IN AUX 1
HDMI Video/
Audio out
STB
(Set Top Box)
etc.
HDMI OUT
Digital audio
out (optical)
Blu-ray Disc player/
DVD recorder, etc.
11
RQT9478