Panasonic SC-HTR200 Operating Instructions Manual page 12

Installing and assembling the rack (cont.)
Installing a Blu-ray Disc player/DVD recorder or other equipment on the shelf
(Please also refer to the other equipment's operating instructions.)
1
Use a utility knife to remove the cut-out on
the back panel of this unit after installing the
equipment.
• Extend the blade of the knife between about
5 mm and 10 mm and cut with care.
• Refer to pages 14 to 18 for connections with
other equipment.
• When installing equipment that produces heat,
remove the cut-out to allow ventilation.
2
Pass the equipment's cables through the cut-out.
Note
• Do not put equipment weighing more than 12 kg on the upper shelf or more than 20 kg on the lower shelf.
• Image interference may occur if you put a DVD recorder, etc. on the upper shelf. Put it on the lower
shelf if this occurs.
• Refer to the following table before installing equipment in the rack.
Compartment
Installing the television (refer also to the television's operating instructions.)
Recommended: 42 inches or less
Attach the stand to the television.
Preparation
Place the television (with stand attached) in the centre of the rack.
12
RQTV0311
Dowel position
Upper shelf
H
Lower shelf
W
D
Front view
Upper Middle
98 128
103 73
730
400
Television stand
Rear view
Cut-outs
Utility knife
UNIT: mm
Lower
158
43