Adjusting Speaker Output; Real Center Function; Reducing Standby Power Consumption (Standby Mode) - Panasonic SC-HTR200 Operating Instructions Manual

Adjusting speaker
output
Adjust the output
of each speaker to
balance with front
speakers according
to the seating area.
REAL CENTER
function
Makes the dialogue
from the center
speaker clearer when
playing surround
sources.
Factory setting is
"ON". See right to set it
"OFF".
Reducing
standby power
consumption
(Standby mode)
HDMI standby
( page 14) does
not work in this
mode if you have
connected through
the HDMI terminal.
VIERA Link
( pages 24 and
25) will not function
when this unit is off.
 Only appears when audio adjustment can be made.
Press .
1
• Test signal is output from one speaker at a time for two seconds in the following
order.
L (Front left) → C (Center) → R (Front right) → SUBW (Subwoofer)
Press to adjust front
2
speakers' normal listening volume.
Press or
3
each speaker's output level.
• You cannot adjust the front speaker level with this process.
• The test signal comes from the speaker being adjusted.
• Test signal is output again in above order 2 seconds after adjustment.
4
Press to stop test signal.
Press and hold
1
to select "REAL C.".
2 Press
REAL C.,
TV DELAY, DRCOMP, ATTENUATOR, REMOTE,
INPUT MODE, RESET, EXIT
to select "OFF".
Press
3
• The effect changes as soon as you select "ON" or "OFF" but you must press [OK] to
confirm selection.
4
Press a few times to select
"EXIT".
• Return to previous menu/cancel.
Press and hold for about 2 seconds.
1
Press to select "HDMI".
2
REAL C.,
TV DELAY, DRCOMP, ATTENUATOR, REMOTE,
INPUT MODE, RESET, EXIT
to select "STNBY".
Press
3
Press to select "OFF".
4
OFF : Standby power consumption reduced
ON: Normal standby power consumption
5 Press a few times to select
"EXIT".
• Return to previous menu/cancel.
to adjust
Adjustment range: OFF, MIN, 1 to 19, MAX
Adjustment range: –10 to +10
Factory setting: 0
for about 2 seconds.
BASS, TREBLE, SLEEP, HDMI,
 
ON, OFF
Press
BASS, TREBLE, SLEEP, HDMI,
 
STNBY, CTRL
(approximately 0.4 W)
Press
Speaker
Press to
confirm.
• Select "EXIT" and
confirm to finish the
setup mode.
Press to
confirm.
Factory setting: ON
Press to
confirm.
Press to
confirm.
Select "EXIT" and
•
confirm to finish the
setup mode.
Press to
confirm.
Press to
confirm.
Factory setting: ON
Press to
confirm.
27
RQTV0311