Messages And Signals - Sharp UX-108 Operation Manual

Messages and Signals

Display messages
Note: If you have turned on the Caller ID function, see "Caller ID" in
Chapter 7 for display messages related to Caller ID.
DOCUMENT JAMMED
FUNCTION MODE
HOLD
LINE ERROR
LINE IS IN USE
NO DATA
NO # STORED
OUT OF PAPER
ON HOOK DIAL
OVER HEAT
The original document is jammed. See the following
section, "Clearing Paper Jams".
The FUNCTION key has been pressed.
The HOLD/SEARCH key has been pressed to put
the other party on hold during a phone conversation.
Press the HOLD/SEARCH again to take the other
party off hold.
Transmission or reception was not successful. Press
STOP to clear the message, and then try again. If the
error persists, see "Line Error" in "Problems and
Solutions" in this chapter.
An extension phone connected to the fax is being
used. Do not lift the fax's handset or attempt
transmission at this time, as this will interrupt the
conversation on the extension phone.
This appears if you attempt to search for an
automatic dialing number when none have been
stored.
You have tried to dial or clear a Rapid Key or Speed
Dial number that hasn't been programmed (a full
number hasn't been assigned to it).
You have run out of fax paper. Load a new roll of fax
paper as described in "Loading the Fax Paper" in
Chapter 1.
The SPEAKER key has been pressed and the fax is
waiting for you to dial. (To return to the date and time
display, press the SPEAKER key again.)
The print head has overheated. Operation can be
continued once it cools.
Display Messages
79