Receiving A Message - Panasonic KX-FC238FX Operating Instructions Manual

4. Telephone
L To send the message without saving it,
select "No", then press {>}.
8
To send the message, select "Send", then
press {>}.
L To cancel sending, press {ih}.
Note:
L This unit supports SMS messages of up to
612 characters, however, the maximum
number of characters you can send or
receive may be limited by your SMS service
provider. Consult your SMS service provider
for details.
L If your message contains over 160
characters, "@@Long Message@@" is
displayed. Your service provider may treat
long messages differently from other
messages. Consult your SMS service
provider for details.
L "Invalid Number" is displayed if you try to
send a message to a phone number saved in
the handset phonebook, Caller ID list, or
redial list that is over 20 digits long.
L When sending a message, "Sending
Message" is displayed momentarily, then
"Transferring Message" is displayed.
L If your unit is connected to a PBX, store the
PBX line access number (page 42).
4.13.2 Displaying / Sending a
saved message
1
Press {j/OK}.
2
Select "SMS", then press {>}.
3
Select "Send List", then press {>}.
4
To display a saved message, press {e} or
{v} repeatedly to select the message, then
press {j/OK}.
L Messages are displayed in chronological
order and by destination phone number.
5
To send the message, press {j/OK}, select
"Send", then press {>}.
– To send the message to the same
destination number, press {j/OK},
then continue from step 7, "4.13.1 Writing
and sending a new message", page 39.
– To send the message to a different
destination number, erase the
displayed number by pressing {C/T},
then continue from step 5, "4.13.1 Writing
and sending a new message", page 39.
4.13.3 Editing a saved message
1
Press {j/OK}.
40
2
Select "SMS", then press {>}.
3
Select "Send List", then press {>}.
4
Press {e} or {v} repeatedly to select the
message, then press {j/OK}.
5
Press {j/OK}, select "Edit Message",
press {>}, then continue from step 4,
"4.13.1 Writing and sending a new
message", page 39.
4.13.4 Erasing saved messages
1
Press {j/OK}.
2
Select "SMS", then press {>}.
3
Select "Send List", then press {>}.
4
Press {e} or {v} repeatedly to select the
message, then press {j/OK}.
5
Press {j/OK}, select "Erase", then press
{>}.
L To erase all messages, select "Erase
All", then press {>}.
6
Select "Yes", then press {>}.
7
Press {ih}.

4.14 Receiving a message

When an SMS message is received:
– a tone is heard (if the ringer is turned OFF,
this tone is not heard)
– "Receiving SMS Message" is displayed
– F is displayed
– the message centre number is stored in the
Caller ID list (page 35)
{j/OK}
{C}
{s}
{>}{e}{v}
4.14.1 Displaying a received
message
1
Press {j/OK}.
2
Select "SMS", then press {>}.
3
Select "Receive List", then press {>}.
{ih}