Table of Contents
Advertisement
Code #47: Setting the voice guidance
VOICE GUIDANCE
=ON
[±]
If you wish to hear voice guidance, activate this
feature.
"ON" (default): You will hear the friendly
reception voice guide, pre-recorded messages
and voice time/day stamp.
"OFF": Deactivates this feature.
Code #53: Turning SMS ON/OFF
SMS
=OFF
[±]
See page 38 for details.
Code #54: Changing the recording time for
your TAM/FAX greeting message
GREETING TIME
=16s
[±]
"16s" (default): Maximum recording time is 16
seconds.
"60s": Maximum recording time is 60 seconds.
See page 60 for details.
Code #58: Setting the scan contrast
SCAN CONTRAST
=NORMAL
[±]
To send or copy a document with faint or dark
writing, set this feature before transmission or
copying.
"NORMAL" (default): Used for normal writing.
"LIGHT": Used for dark writing.
"DARKER": Used for faint writing.
Code #67: Setting the incoming message
monitor
ICM MONITOR
=ON
[±]
To hear an incoming message (ICM) from the
speaker when the answering device is recording
the message.
"ON" (default): You can monitor the incoming
message.
"OFF": Deactivates this feature.
Code #68: Setting the Error Correction Mode
(ECM)
ECM SELECTION
=ON
[±]
This feature is available when the
transmitting/receiving fax machines are ECM
compatible.
9. Programmable Features
"ON" (default): If there is an error during fax
transmission/reception, the fax machine will
support the communication.
"OFF": Deactivates this feature.
Note:
L You cannot change the setting when received
documents are in memory.
Code #73: Changing the receiving mode in
the manual answer setting
MANUAL ANSWER
=TEL
[±]
"TEL" (default): Telephone mode (page 53)
"TEL/FAX": Telephone/Fax mode (page 54)
Code #76: Setting the connecting tone
CONNECTING TONE
=ON
[±]
If you often have trouble when sending faxes,
this feature allows you to hear connecting tones:
fax tone, ring back tone and busy tone. You can
use these tones to confirm the status of the other
party's machine.
"ON" (default): You will hear connecting tones.
"OFF": Deactivates this feature.
Note:
L If the ring back tone continues, the other
party's machine may not be a fax machine or
may have run out of paper. Check with the
other party.
L The connecting tone volume cannot be
adjusted.
Code #77: Changing the receiving mode in
the auto answer setting
AUTO ANSWER
=TAM/FAX
[±]
"TAM/FAX" (default): Telephone Answering
Machine/Fax mode (page 55)
"FAX ONLY": Fax only mode (page 56)
Code #78: Changing the TEL/FAX delayed
ring setting
TEL/FAX RING
RINGS=2
[±]
If you use an extension telephone in TEL/FAX
mode, select the desired number of times the
extension telephone rings before the unit
answers the call. You can select "1", "2"
(default), "3", "4", "5", "6", "7" "8" or "9". See
page 54 for details.
69
Advertisement
Table of Contents
