Installation - Panasonic WV-CS650 Operating Instructions Manual

INSTALLATION

Precaution:
The following installations should be made by
qualified service personnel or system installers.
Setting the camera switches
(only for WV-CSR650)
• To reset the communication parameters to
the factory preset values, for example, when
operating multiple cameras in a daisy chain
connection, set the switches inside the
camera as shown in the table below.
1. Disassemble the camera
Confirm the power is turned off.
Remove the screw from inside the hole for
the fall prevention wire. Hold the diecast
case containing the camera and rotate it to
the left as shown below.
Note: Setting of switches while the power is
on may cause a malfunction. Make sure
the power is turned off before setting
the switches.
Diecast Case
2. Setting the switches
Set the switches as follows:
Switch B
Termination
ON
Switch A: Full duplex (four lines)/Half duplex
(two lines) switch
Switch B: Termination ON/OFF switch
Switch C: Dip switches (become effective
when the power is turned on)
Initialization of soft-
ware communica-
tion parameters
Notes:
• Select OFF after resetting the parameters by
selecting ON.
• The factory settings is OFF.
Camera Unit No.
The factory settings for the dip switch 1 and 2
are OFF both.
- 31 -
DIP Switches
ON
OFF
OFF
Switch A
Full Half
(4 lines) (2 lines)
OFF Normal Setting
DIP 3
Initial
ON
Settings
DIP 1 DIP 2
OFF OFF 01 - 32
OFF ON 33 - 64
ON OFF 65 - 96
ON ON Inhibition