Panasonic WV-CS650 Operating Instructions Manual page 14

Changing the camera communication parameters
1. Display the SET UP MENU. Move the cursor to COM. SET UP DISABLE and press the CAM (SET)
key to select COM. SET UP ENABLE.
2. Move the cursor to the item and select the parameter by moving the joystick to the left or right.
You can remote control this camera by using a specified extension
unit such as a computer with a modem. The RS485 menu is used to
set the parameters of the below items for RS485 site com-
munication.
Move the cursor to RS485 of the SET UP menu and press the CAM
(SET) key. The RS485 menu appears on the monitor screen.
UNIT NUMBER
Specifies the camera ID numbers in case more than two cameras and WV-RM70 controllers are daisy
chain connected. Select (1-32), (33-64) or (65-96) with the dip switch. The factory setting is 1.
BAUD RATE
Specifies the transmission speed (2 400, 4 800, 9 600, 19 200 bps) for the RS485 communication. (BAUD
is a unit equal to bits per second.) The factory setting is 19 200.
DATA BIT
Specifies the number of data bits (7 or 8 bits) for the RS485 communication. The factory setting is 8.
PARITY BIT
Specifies the parity bits (NONE, ODD, EVEN) for the RS485 communication. The factory setting is NONE.
STOP BIT
Specifies the number of stop bits (1 or 2 bits) for the RS485 communication. The factory setting is 1.
X ON/X OFF
Specifies whether to apply flow control or not (NOT USE, USE) for the RS485 communication. The factory
setting is NOT USE.
WAIT TIME
Specifies the time to wait until retransmitting after confirming that no data is received from the controller.
(OFF: no transmission, 100, 200, 400, 1 000 ms).
ALARM DATA
Specifies the alarm data transmission mode (POLLING, AUTO 1, AUTO 2). The factory setting is AUTO 2.
POLLING:
Transmit the alarm data to the controller against request from the controller.
AUTO 1:
Transmit the alarm data each time the alarm signal is received.
AUTO 2:
Transmit the alarm data every five seconds. (This mode is recommended when WV-CU550A is
used).
- 11 -
Setup menu
for camera communication
(only for WV-CSR650)
*** SET UP MENU ***
CAMERA*
UNIT NUMBER 1
BAUD RATE 19200
DATA BIT 8
PARITY BIT NONE
XON/XOFF NOT USE
WAIT TIME OFF
ALARM DATA AUTO 2
DELAY TIME OFF
COM. SET UP DISABLE