Hardware Configuration Commands - H - Hand Held Products SV Series User Manual

Example return using ScanView:
Scan Rate: 400
~DN#
Inquire port activation data.
This command instructs the verifier to report all parameters of the event that
caused this port to go active.
# = 1 through 8 (port ID)
~DV
Inquire firmware version.
1. Commands the verifier to transmit the SV Series firmware version to the host
in the following data packet format:
2. ~D
3. hexadecimal value '4' - identifies the beginning of the data packet response
4. The following character string between the quotes: 'Version: '
5. Five alphanumeric characters that specify the version number. They can
include trailing spaces. (See example below.)
6. hexadecimal value '5' - identifies the end of the data packet response
7. V
Example return using ScanView:
Version: X327
~De#
Select reply format for ~HT command.
# = values of 0 or 1.
# = 0 sets the normal ~HT reply as shown in the ~HT command description.
# = 1 sets an alternate ~HT command reply. Additional advanced command
statuses are provided and all commands are listed in alphabetical order.
Hardware Configuration Commands – H
A '~', immediately followed by an 'H', specifies a command from the 'Hardware'
category. All Hardware Commands require one additional character that
identifies the particular Hardware Command. The Hardware Commands are
listed below.
~HB#
Set the Baud Rate.
6 - 6 Quick Check® SV Series User's Guide