Hand Held Products SV Series User Manual page 50

~BCa##bc{...bbb...}{...mmm...}{...bbb...}... {etc. up to 32 characters max.}
Check for specific data
This command sets (enables) or clears (disables) one of 10 available data match
arrays. All ten arrays may be active simultaneously. A data match error occurs
if at least one array is active and the data scanned does not match the data
programmed in the array. Each array can be up to 32 characters in length.
Multiple portions of each array can be masked and the mask character is defined
in the command. The data in the array must consist of printable ASCII characters
with ASCII values less than 128.
~BC
a
##
b
c
...bbb...
...mmm...
...bbb...
6 - 2
Data Match Command
1 digit. A number between 0 and 9. It identifies the data
match array being programmed or cleared.
Number of data characters in the Data Match array. The
value can be 01 through 32. A value of 00 clears (disables)
this array.
This character defines the fill character for masking pur-
poses. This character cannot be a character to be matched
in the match field mmm.
This character defines the size of the data match field to be
fixed ("f") or variable ("v"). If variable, the data in the field is
left justified in a 32 character possible field.
Fill characters prior to the Data Match text. These charac-
ters must match the character defined by b in the command.
Data Match Character Field. This can be from 1 to 32 char-
acters. These define the exact characters that must be
matched.
Fill characters after to the Data Match text (if needed)
Quick Check® SV Series User's Guide
.