Hand Held Products SV Series User Manual page 76

~SR
Reset the System.
This re-initialization procedure recalls all of the current setup parameters from
the flash.
~SSbbbeee
Program the start and end characters in a transmission
bbb = decimal value of the ASCII character that indicates the beginning of a
transmission. eee = decimal value of the ASCII character that indicates the end
of a transmission. Allowed values for bbb and eee are 001 through 127.
Example ~SS083069 causes an S to be the beginning character and an E to be
the ending character of a data transmission. This command applies only when
the standard transmission mode is enabled (~HQ0.) The command ~SS013010
must be used when operating with RJS ScanView software.
~SY
Software Sync for communication output modes #1 and #2 (~HO1, ~HO2);
trigger a sync response from the verifier, and enable the verifier
~Sh##
Set the high target reflectance value for calibration.
## - The high target reflectance value (70 to 99).
This sets a new high reflectance target value for a calibration symbol.
To use the target values encoded in the calibration symbol set this value to 00.
~Sl##
Set the low target reflectance value for calibration.
## - The low target reflectance value (1 to 20).
This sets a new low reflectance target value for a calibration symbol.
To use the target values encoded in the calibration symbol set this value to 00.
~Ssxy
Program header and trailer characters in a standard transmission format.
This command is similar to ~SS, but allows a programmable number of
characters that begin and end the standard transmission, where ~SS has a fixed
single character for both start and end of the transmission.
x = number of characters in the header. Allowed values are 0,1,...9 therefore up
to nine header characters are available.
6 - 28 Quick Check® SV Series User's Guide