Laser Beam - Hand Held Products SV Series User Manual

The CE mark on the product indicates that the system has been tested
to and conforms with the provisions noted within the 89/336/EEC
Electromagnetic Compatibility Directive and the 73/23/EEC Low
Voltage Directive.
For further information please contact:
Hand Held Products, Inc.
Nijverheidsweg 9
5627 BT Eindhoven
The Netherlands
Hand Held Products shall not be liable for use of our product with equipment
(i.e., power supplies, personal computers, etc.) that is not CE marked and does
not comply with the Low Voltage Directive.
Statement of RoHS Compliance:
All SV Series units with appropriate part numbers conform to requirements
specified in DIRECTIVE 2002/95/EC OF THE EUROPEAN PARLIAMENT AND
OF THE COUNCIL of 27 January 2003 on the restriction of the use of certain
hazardous substances in electrical and electronic equipment.
SV Series Use with UL-listed Equipment
The SV Series should be used only with printers, applicators, conveyors, etc.
that are UL listed. The SV Series is intended to be supplied by a UL Listed power
supply (QCOLVPS) or receives power from the host unit (UL Listed Printer),
output rated 5Vdc, minimum 300mA maximum 2A.
Cautions
• Never stare directly into the laser beam.
• Never stare directly at a reflected image of the laser beam.
• Avoid exposure to the laser beam.
• Use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure.
• Use the SV Series only with UL-listed bar code printers, applicators,
conveyors, etc.

Laser Beam

The laser beam may be on at any time the Power/Sync LED is illuminated.