Output Mode Selection Commands - O - Hand Held Products SV Series User Manual

~Lt#
Turn partials on and off at the decoder level for Interleaved 2 of 5 codes only.
0 Disable
1 Enable
Output Mode Selection Commands – O
A '~' followed by an 'O' specifies a command from the Output Mode Selection
category. These commands include one additional character that identifies the
particular Output Mode Command. The Output Mode Selection Commands are
listed below.
~OL##
Set an LED on/off. (Does not over-ride normal operation; recommended for use as
diagnostic in Mode 0 (~LV00) only)
First '#' - Possible values are '1','2'. Identifies the LED.
Second # - Possible values are '1' (on), '0' (off).
~OP##
Set a PORT on or off. (Does not over-ride normal operation; recommended for use
as diagnostic in Mode 0 (~LV00) only)
First # - Possible values are '1','2','3','4','5'. Identifies the port.
Second # - Possible values are '1' (on), '0' (off).
~OS#
Set Transmission Data Format
This command is effective only if the standard transmission mode is enabled via
the ~HQ0 command.
0 = Standard transmission format as described in the Serial Port Transmission
Format Section
1 =Standard transmission format modified; analysis parameters a through N
included, but encoded data is formatted as data characters only rather than all
symbol characters. The data consists only of printable ASCII characters and
does not include any mandatory symbol characters such as stop, start and
symbol mod check characters. One exception is in UPC/EAN codes, the mod 10
check digit is included.
6 - 18 Quick Check® SV Series User's Guide