Water Supply Requirements - Hoover H160I Instructions For Use Manual

05651238.qxd 29-05-02
If the inlet hose's connection point is changed, check that the 3/4" threaded ferrule
on the inlet hose is firmly attached to the electrovalve connector.

Water supply requirements

Connect the machine to the drainage system used by household sinks.
THIS MACHINE MUST BE CONNECTED IN
THIS MACHINE MUST BE CONNECTED IN
ACCORDANCE WITH THE WATER SUPPLY
ACCORDANCE WITH THE WATER SUPPLY
REGULATIONS. WATER BYELAWS PROHIBIT
REGULATIONS. WATER BYELAWS PROHIBIT
CONNECTION TO A SURFACE WATER DRAIN.
CONNECTION TO A SURFACE WATER DRAIN.
No other appliance should be plumbed into the standpipe.
There are two possible arrangements which can be seen below :-
HOSE SUPPORT
CROOK
DRAIN HOSE
12-15cm
32mm
min
For the washing machine to function properly the outlet end of the drain
hose must be at a minimum of 60 cm and a maximum of 80 cm from the
ground.
10:10 Page 8
8
FIX SECURELY
ABOVE OVERFLOW
OUTLET OF SINK
HOSE SUPPORT CROOK
DRAIN HOSE
ATTACH HOSE
SECURELY TO
WASTE OUTLET