Quick Start - Hoover H160I Instructions For Use Manual

05651238.qxd 29-05-02
K) When moving the appliance never lift it by the controls, the detergent drawer, the hoses or
the power cable.
To avoid damaging the door when moving the appliance never rest the door against objects
e.g a trolley.
L) IMPORTANT!
If the appliance is installed on a carpeted floor ensure that the ventilation through the base
of the appliance is not obstructed.
M) When lifting the machine always use two people to help avoid injuries.
N) If the appliance is not running properly or breaks down, switch it off, disconnect the plug
from the socket, turn off the water supply and do not tamper with the appliance.
Consult GIAS Service (tel: 08705 400 600) for possible repair. Failure to comply with the
above can compromise the safety of the appliance.
O) If the appliance's power cable is damaged it must be replaced by a special cord which is
only available from GIAS Service.
P) After the machine has been installed, ensure that the mains plug and water supply valves
are easily accessible.
Q) Glass fibre curtains should never be put into this machine.
R) Lint or fluff must not be allowed to collect on the floor around the outside of this machine.
S) Always ensure that the door locked indicator neon has switched itself off before opening the
door. By doing so the machine is allowed to cool down before the laundry is handled.
T) Always ensure that the base panel is fitted to the machine.
Note: Please ensure that Inter@ct set-up, installation and testing
has been completed before referring to the Quick Start.
Washing
– Open the door with the DOOR button
– Select laundry and put it in the machine
– Close the door
– Put detergent in the dispenser compartments
– Select programme by turning the programme knob (Your desired programme may be seen
on the display)
– Select any function buttons required and then press the Start/Pause button
– There may be a short time delay from pressing the Start/Pause button to the start of the
programme, while the machine senses the water required and sets the parameters for the
programme
After washing
– Wait about two minutes for the door locking device to
disengage. The door locked neon will go out.
– Switch off the machine by turning the control knob to the OFF
position
– Open the door and remove the laundry
10:10 Page 5

Quick Start

5