Water Supply Requirements - Hoover ACM16 Instructions For Use Manual

05651295.qxd 31-07-03
Cold Water Supply

Water supply requirements

Connect the machine to the drainage system used by household sinks.
THIS MACHINE MUST BE CONNECTED IN
ACCORDANCE WITH THE WATER SUPPLY
REGULATIONS. WATER BYELAWS PROHIBIT
CONNECTION TO A SURFACE WATER DRAIN.
No other appliance should be plumbed into the standpipe.
There are two possible arrangements which can be seen below :-
HOSE SUPPORT
CROOK
DRAIN HOSE
12-15cm
32mm
min
For the washing machine to function properly the outlet end of the drain
hose must be at a minimum of 60 cm and a maximum of 80 cm from the
ground.
21:53 Page 8
If you have no hot water supply or your hot
water pressure is low:
A cold fill adapter , allowing the installation of the
machine with a cold water supply only can be
purchased from Gias Service
(Tel. No. 01204 556111).
8
FIX SECURELY
ABOVE OVERFLOW
OUTLET OF SINK
HOSE SUPPORT CROOK
DRAIN HOSE
ATTACH HOSE
SECURELY TO
WASTE OUTLET