Table of Contents
Advertisement
05651238.qxd
29-05-02
10:10
Page 18
inform you of the chosen programme, its temperature and the newly selected spin speed.
Energy Saver button
This option can be utilised on all programmes. By selecting the Energy Saver option the wash
temperature is limited to the water inlet temperature. It is particularly suggested in the case of
lightly soiled fabrics, and allows you to save 80% of energy compared with the normative at
60%.
Set End Time/Start Delay buttons
The set end time/start delay options can be used if you want the washing to be ready at a
later time (but within 24 hours).
1. Set start delay button
Press start delay/set end time button once and press the hours and minutes buttons (to the
left and right) until the required time is set. The display returns to the programme option if
the button is pressed within 5 seconds. Once you have set the required start delay/end
time, press the start button
To cancel delay start, hold down the button for 5 seconds.
2. Programme set end time button
Press start delay/set end time button twice and press the hours and minutes buttons (to the
left and right) until the required time is set. When entering the set end time option, the
display will show the minimum time which you can set the programme to end by. This time
may only be extended as you require.
NOTE: When using the start delay/set end time functions, only use detergents via the
dispenser drawer. Adding detergents etc. to the drum and then leaving them to stand for a
long period of time may damage your laundry.
Fast Iron button
This option is available on cottons, synthetics, delicates and the Handwash special
programme. When this option is selected for cottons, woollens and the Handwash
programmes, the machine will stop in the final rinse stage and the load will be held within
the water in the drum. This reduces the creasing thus enabling easier ironing. To continue
with the wash cycle, press the "Fast Iron" button and the programme will restart.
When the option is selected for synthetics the programme is completed by a short, very low
spin speed. The laundry may be left in the drum in this condition without the risk of
excessive creasing. If a spin cycle is required please select the appropriate spin (see
Programme Guide).
When the option is selected for delicate programmes, the machine stops in the final rinse
stage and the load will be held within the water in the drum, thus reduces creasing and
enabling easier ironing. Press the "Fast Iron" button to continue with the programme. The
machine will then pump out the remaining water and the programme will conclude with a
low speed spin for approximately 15 seconds. Finally, the programme carries out a brief
tumbling action to "loosen" the items in the load.
18
Advertisement
Table of Contents
