Table of Contents
Advertisement
05651238.qxd
29-05-02
Remove the machine from the
packaging - close to where it will finally
be positioned - and proceed as follows:
On the back of the machine
1) Remove the central screw A and side
screws B and pull out the transit bracket C
complete with the red spacer.
2) Tilt the machine forward and remove the
polystyrene spacers.
3
Cover the central hole using the cap
enclosed in the instructions bag.
4) Adjust the two feet at the front to level the
machine.
5) Tilt the machine forward and locate the
base panel by ➀ removing the paper
backing from the adhesive tape, ➁ locate
the base panel in the front of the machine
➂ offer the base panel up to the base of the
washing machine and locate the two clips.
10:10
Page 6
Installation & Testing
6
Advertisement
Table of Contents
