Hoover H160I Instructions For Use Manual page 13

05651238.qxd 29-05-02
Set New Time
This function needs to be set for two reasons – firstly to display the current time of
day on the screen and secondly for the programme set end time/delay start
settings to work correctly.
You will notice in the display window that the hours on the clock will be flashing.
Set the hours by continually pressing the "Extra Rinse" button and then press the
"Time Saver" button to enter the hour. Next the minutes on the clock will begin to
flash, again press the "Extra rinse" button until the required minutes are displayed
and press "Time Saver" to input the selection.
When you have Set the New Time, the display will then ask if you wish to "Set the
Time Mode".
Setting the time mode
There are two ways to select the time mode.
The first is if you wish programme end time or start delay to be programmed by
starting the actual time you want the programme to end or begin, e.g., programme
to end 08.00. This is called Absolute Time Mode. When utilising the Set End Time
function (or start delay), an example can be seen below when the Absolute Time
Mode has been selected in the menu set-up stage.
Therefore, when setting the programme end time the programme (as shown
above) will end at 08.00.
The second is if you wish programme end time or start delay to be programmed
by adding hours; e.g., programme to end in 1 1 /2 hours. This is called Relative
Time Mode. When utilising the set end time function (or start delay) an example
can be seen below when Relative Time Mode has been selected is the menu set-
up stage.
Therefore, when setting the programme end time the programme (as shown
above) will end at 15:30.
Both options are very useful, but we feel that the Absolute Time Mode will be
more beneficial and easier to use since there will be no need to calculate how
many hours you will need to leave before you want the machine to end or start.
10:10 Page 13
(default setting – ABSOLUTE)
PROGRAMME END
08.00
PROGRAMME END
BY 1H 30M
13
14:00
14:00