Copy Settings; Add Or Change Extra Preset Ratios; Setting A Maximum Number Of Copies - Oce cm4010 System Settings Manual

Copy Settings

The following settings are related to copying. Touch the [Copy Settings] key and configure the settings.
Default settings selected with these settings apply to all functions of the machine (not just the copy function).
Initial Status Settings
The copier settings are reset when the [POWER] key
( ) is turned on, when the [CLEAR ALL] key (
pressed, or when the auto clear interval has elapsed.
These settings are used to change the default settings
for copy mode. The following settings can be changed:
• Color Mode
• Paper Tray
• Exposure Type
• Copy Ratio
• 2-Sided Copy
• Output (output method and output tray)
Touch each key and configure the settings.
If you wish to return a changed default setting to the
original setting, touch the [Return to the Factory Default
Setting] key.
If this setting is used to change the default setting for
the duplex function to other than "1-Side to 1-Side"
and the duplex function or automatic document feeder
fails or is disabled, the setting will revert to "1-Side to
1-Side".
Exposure Adjustment
This is used to adjust the exposure level when "Auto" is
used for the copy exposure.
Touch the [Color] key or the [B/W] key, select the
exposure level with the
document glass and the automatic document feeder, and
touch the [OK] key. Lower the level toward "1" for lighter
exposure or raise the level toward "9" for darker exposure.
Rotation Copy Setting
When the original and paper are placed in different
orientations, this function automatically rotates the image
90 degrees to enable correct copying on the paper.
To enable this setting, select the checkbox
touch the [OK] key.
• Rotation copy will operate only if Auto Paper
Selection or Auto Image has been selected.
• The Rotation Copy setting must be enabled when
copying 5-1/2" x 8-1/2" (A5) size original on
5-1/2" x 8-1/2"R (A5R) paper.
) is
keys for both the
and

Add or Change Extra Preset Ratios

Two enlargement preset ratios (101% to 400%) and two
reduction preset ratios (25% to 99%) can be added. An
added preset ratio can also be changed.
System Settings
Add or Change Extra Preset Ratios
Select the "Reduction" key or the "Enlargement" key,
specify the value with the
[OK] key. (To make the number change quickly, keep
your finger on the
Preset ratios other than added preset ratios cannot be
changed.
Setting a Maximum Number of
Copies
This is used to set the maximum number that can be
entered for the number of copies (number of continuous
copies). Any number from 1 to 999 can be specified.
Enter the number with the numeric keys and touch the
[OK] key.
96
Reduction Enlargement
(25 99) (101 400)
keys, and touch the
or key.)
OK