Set Up Instructions - Stamina 1701 Owner's Manual

SET UP INSTRUCTIONS

Place the 1701 Dual Action Elliptical in the area where it will be used. It is recommended that the 1701
Dual Action Elliptical be placed on an equipment mat. The maximum operation dimensions of the 1701
Dual Action Elliptical are approximately 40.8 inches long x 24.8 inches wide x 60.4 inches tall. (These
dimensions may vary up to one inch.) An area 4 feet wide x 6 feet long is required for safe operation of
the 1701 Dual Action Elliptical. Make sure that adequate space is available for access to and passage
around the 1701 Dual Action Elliptical.
LEVELING: Adjust the LEVELING CAPS(57) on the REAR STABILIZER(3) so that the 1701 Dual Action
Elliptical sits on the floor without rocking. Remove and reposition the LEVELING CAPS(57)
on the REAR STABILIZER(3) to level the 1701 Dual Action Elliptical.
MOVING: Grasp the pivot tubes on the PIVOTING ARMS(9, 10) and REAR STABILIZER(3) to move
the 1701 Dual Action Elliptical, two people are required for moving. Do not use the PEDAL
ARMS(4, 5) to move the 1701 Dual Action Elliptical. The PEDAL ARMS(4, 5) will move and
may pinch your hand or fingers.
FUNCTION INSPECTION:
Visually inspect the 1701 Dual Action Elliptical to verify that assembly is as shown in the above illustration.
Check the function of the 1701 Dual Action Elliptical by turning the crank slowly through one complete
revolution to verify that the drive train functions properly. Adjust the TENSION KNOB(31) to verify that the
adjustable tension is working properly.
CAUTION: Locate and read the WARNING LABEL(76) on the 1701 Dual Action Elliptical. Make sure
that all users read the WARNING LABEL(76).
Grasp here to move
Equipment Mat
13
Grasp here to move
(not included)