Stamina 1701 Owner's Manual page 12

Dual action elliptical

Table of Contents

ASSEMBLY INSTRUCTIONS

STEP 9:

There is an "L" decal on the LEFT PIVOTING ARM(9), and an "R" decal on the RIGHT PIVOTING

ARM(10). To assemble the RIGHT PIVOTING ARM(10), place a SPACER(50) and a LARGE WASHER

(M16)(51) onto the right side of the SHAFT on the UPRIGHT(6). Slide the RIGHT PIVOTING ARMS(10) onto

the SHAFT and secure with a LARGE WASHER(M8)(44), LOCK WASHER(M8)(75), and BUTTON HEAD

BOLT(M8x1.25x20mm)(59). Attach the LINKAGE(11) to the RIGHT PIVOTING ARM(10) with the PLASTIC

WASHERS(M8)(48), BUTTON HEAD BOLTS(M8x1.25x48mm)(60), and NYLOCK NUTS(M8x1.25)(68).

Repeat on the left side.

STEP 10:

Attach the LEFT and RIGHT HANDLEBARS(7, 8) to the LEFT and RIGHT PIVOTING ARMS

(9, 10) with HEX BOLTS(M6x1x36mm)(63), ARC WASHERS(M6)(72), LOCK WASHERS(M6)(74), and

ACORN NUTS(M6x1)(70). The HEX BOLTS(M6x1x36mm)(63) fit inside the hex-shaped holes in the

HANDLEBARS(7, 8).

STEP 11:

Look down from the top of the UPRIGHT(6) to make sure the pivot tubes on the PIVOTING

ARMS(9, 10) are parallel to the FRONT STABILIZER(2) and the PEDAL ARMS(4, 5) are crossing the

ROLLERS(54) properly. Tighten the BUTTON HEAD BOLTS(M8x1.25x20mm)(59) as described in

STEP 3 on the UPRIGHT(6).

STEP 12:

Install two AA batteries into the METER(32), the batteries are not included. See page 15 for

detailed battery installation instructions. Remove the red strap from the SENSOR WIRE(33). Plug the

SENSOR WIRE(33) into the METER(32), and push the excess wire back into the UPRIGHT(6). Slide the

METER(32) onto the plate on the UPRIGHT(6).

Shaft

Table of Contents

55-1701