Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
STEP 4
Refer to illustration 1 below. Turn the TENSION KNOB(31) counterclockwise as far as it can go, so the
HOOK moves down to the lowest position. Remove the black strap from the TENSION CABLE(30). Connect
the CABLE END of the TENSION CABLE(30) into the HOOK on the TENSION KNOB(31) as shown in
illustration 2. Pull firmly on the TENSION CABLE(30) so that enough cable is available to insert its PLUG
END into the SOCKET of the TENSION KNOB(31). The TENSION KNOB(31) and the TENSION CABLE(30)
should look as shown in illustration 3. Adjust the TENSION KNOB(31) and verify that the HOOK moves
when the TENSION KNOB(31) is adjusted.
STEP 5
Hook
the TENSION KNOB(31) into the square hole on the UPRIGHT(6) and secure with FLAT HEAD
SCREW(M5x0.8x15mm)(67).
1.
2.
3.
Hook
Hook
Cable End
Socket
Plug End
9
Advertisement
Table of Contents
