Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
STEP 3
NOTE:
There is a red strap and a black strap attached inside of the UPRIGHT(6). These straps are to
assist in pulling the SENSOR WIRE(33) and TENSION CABLE(30) through the UPRIGHT(6).
Tie the red strap to the plug end of the SENSOR WIRE(33). And tie the black strap to the cable end of
the TENSION CABLE(30). Pull the straps from their top ends to pull the SENSOR WIRE(33) through to
extend out of the top of the UPRIGHT(6), and pull the TENSION CABLE(30) through and extend out from
the square hole at the side of the UPRIGHT(6) as shown in the below illustration.
Insert the UPRIGHT(6) into the MAIN FRAME(1) and secure with BUTTON HEAD BOLTS(M8x1.25x20mm)
(59), LOCK WASHERS(M8)(75), and ARC WASHERS(M8)(73). Do not tighten the bolts until STEP 11.
NOTE: Don't remove the straps from the SENSOR WIRE(33) and TENSION CABLE(30) until instructed
to do so in later assembly steps.
Black Strap
Red Strap
8
Advertisement
Table of Contents
