Factory Default Settings - NETGEAR JWNR2000v2 User Manual

Factory Default Settings

Table 1. Router Default Settings
Feature
Router Login URL
Login name (case-sensitive)
Login password (case-sensitive)
WAN MAC address
MTU Size
LAN IP address (gateway IP address)
Router subnet
DHCP server
DHCP range
Time zone
Adjust for daylight saving time
Allow a registrar to configure this router
Wireless communication
SSID Name
Security
Wireless access list (MAC Filtering)
Broadcast SSID
Transmission speed
Country/Region
RF channel
Operating mode
Data rate
Output power
Inbound communication from the Internet
Outbound communication to the Internet
*. Maximum wireless signal rate derived from IEEE Standard 802.11 specifications. Actual throughput will vary.
Network conditions and environmental factors, including volume of network traffic, building materials and
construction, and network overhead lower actual data throughput rate.
98 | Appendix A. Supplemental Information
NETGEAR N300 Wireless Router JWNR2000v2 User Manual
Default Setting
http://www.routerlogin.net or http://www.routerlogin.com
admin (printed on product label)
password (printed on product label)
Default hardware address (on label)
1500
192.168.1.1 (printed on product label)
255.255.255.0
Enabled
192.168.1.2 to 192.168.1.254
GMT
Disabled
Enabled
Enabled
NETGEAR
Disabled
All wireless stations allowed
Enabled
*
Auto
United States in NA only, otherwise varies by country and region
6 until region selected
145 Mbps
Best
Full
Disabled (bars unsolicited requests except traffic on port 80, the
http port)
Enabled (all)