NETGEAR JWNR2000v2 User Manual page 8

The router front panel has status LEDs and icons shown in the figure.
Figure 2. Front panel LEDs and icons
Table 1. Front Panel LEDs
Icon LED Activity
LAN ports Solid green
1–4
Blinking green
Solid amber
Blinking amber
Off
Wireless
Solid green
Blinking green
Off
Internet
Solid green
(WAN)
Blinking green
Off
WPS Solid green
Blinking green
Off
Power/ Solid green
Check
Fast blink green
Slow blink green
Off
8 | Chapter 1. Hardware Setup
NETGEAR N300 Wireless Router JWNR2000v2 User Manual
LAN ports Wireless
Description
The local port is connected to a 100 Mbps device.
Data is being transmitted at 100 Mbps.
The local port is connected to a 10 Mbps device.
Data is being transmitted at 10 Mbps.
No link is detected on this port.
The wireless interface is enabled.
Data is being communicated over the wireless network.
The wireless interface is turned off.
The router has acquired an Internet address.
Data is being communicated with the Internet.
No Ethernet cable is connected to the modem.
Indicates a (WPS) connection to a WPS-capable device.
WPS-capable device can associate with the router within 2 minutes.
No WPS connection exists.
The power is on and the router is ready.
A software update is in progress.
Performing basic power-on self-test diagnostic, or firmware is corrupted
(see
Troubleshooting Basic Functions
Power is not being supplied to the router
Internet WPS Power/Check
on page 88).