Block Services By Ip Address Range; Set The Time Zone - NETGEAR JWNR2000v2 User Manual

information by contacting the publisher of the application, by asking user groups or
newsgroups, or by searching.
Enter the starting port and ending port numbers. If the application uses a single port
-
number, enter that number in both fields.
If you know that the application uses either TCP or UDP, select the appropriate
-
protocol. If you are not sure, select Both.
Select the radio button for the IP address configuration you want to block, and then enter the
6.
IP addresses in the appropriate fields.
Click Add to enable your Block Services Setup selections.
7.

Block Services by IP Address Range

In the Filter Services For area, you can block the specified service for a single computer, a
range of computers (having consecutive IP addresses), or all computers on your network.

Set the Time Zone

The router uses the Network Time Protocol (NTP) to obtain the current time and date from
one of several network time servers on the Internet. You can check and set (if needed) the
time zone to ensure time stamps match your local time.
Select Security > Schedule to display the following screen:
1.
44 | Chapter 4. Content Filtering
NETGEAR N300 Wireless Router JWNR2000v2 User Manual