Mstp Configuration Example - HP V1910 User Manual

Field
Max age(s)
Forward delay(s)
Hello time(s)
Max hops
Return to MSTP configuration task

MSTP configuration example

Network requirements
Configure MSTP in the network shown in
different MSTIs.
All devices on the network are in the same MST region.

 Packets of VLAN 10, VLAN 20, VLAN 30, and VLAN 40 are forwarded along MSTI 1, MSTI 2, MSTI
3, and MSTI 0 respectively.
Switch A and Switch B operate at the distribution layer; Switch C and Switch D operate at the access

layer. VLAN 10 and VLAN 20 are terminated on the distribution layer devices, and VLAN 30 is
terminated on the access layer devices, so the root bridges of MSTI 1 and MSTI 2 are Switch A and
Switch B respectively, while the root bridge of MSTI 3 is Switch C.
Network diagram for MSTP configuration
a.
NOTE:
"Permit" next to a link in the figure is followed by the VLANs the packets of which are permitted to pass this
link.
Configuration procedure
Table 48 Configure Switch A.
# Configure an MST region.
 Select Network  MSTP from the navigation tree to enter the page shown in b.
Description
Maximum age of a configuration BPDU.
Port state transition delay, in seconds.
Configuration BPDU transmission interval, in seconds.
Maximum hops of the current MST region.
list.
a to enable packets of different VLANs to be forwarded along
199