Table of Contents
Advertisement
Network is switched off: when the network connection of DVR system is lost, the system will
send out the alarm message.
Hard Disk failed: when the hard disk doesn't work normally, the system will send out the alarm
message.
7. In (5) Alarm Reset, click the camera number to set the reset condition of alarm. Once alarm is reset, all
alarm action will stop at the moment. If the sensor normal status is high, set the alarm reset condition to low.
Click IP Camera Sensor to configure sensor status of IP camera. Click High/Low to set sensor status to
high or low.
8. In (6) Action, you may now set the alarm action for the system to perform when the alarm condition is
activated.
- Launch E-Map: Display mini E-map screen.
- Enlarge Camera View
Switch to only display video in Preview mode from where the alarm is activated.
a. Select the camera from drop down list to specify which camera video to be enlarged on screen when
the alarm is triggered.
b. Retrieve time: set the waiting duration before system switching back to original Preview mode. If the
retrieve time is un-set, the alarm video will keep enlarging until user switch back to Preview mode
manually. The retrieve time range is 0~ 600 seconds.
59
CHAPTER 3
Advertisement
Table of Contents
