AVer EH1116H-4 Nano User Manual page 48

- Always Recording
Record the video from the selected camera and save it to the designated storage device
- Motion Recording
Start recording the video from the selected camera only when the system detects movement. Once a motion
is detected, the system automatically saves the previous frames and stop based on the Start Record Prior
and Stop Record After settings.
- Smart Recording
Automatically switch to record at the maximum frame rate setting once a motion is detected and recording
time will be based on Stop Record After setting; if there is no motion, it records at the minimum frame rate
setting. Set the frame rate in (5) Frame Rate.
- No Recording
The system won't do any recording.
(3) Motion Detection
Adjust the sensitivity of the motion detection. The higher the value, the finer the sensitivity is detected. When it
detects a motion, a green triangle mark would appear at the upper left corner of the screen.
(4) Quality
Adjust the video quality. The higher the value, the lower the compression level and uses more hard disk space.
(5) Frame Rate
Set the maximum and minimum number of frames to be recorded during motion and motionless state. The
frame rate ranges from 01 to 30 for NTSC and 01 to 25 for PAL. The higher the frame rate, it uses more hard
disk space.
Always recoding frame rate is depending on value of max frame rate.
(6) Video Size
Select the size of the video and click the
(7) Individual Adjustment
Each camera can adjust video size and frame rate individually. Click Default will back to the factory default
value. The frame rate usage is shown in Used and Unused columns by CIF mode.
Adjusting video size and frame rate by channel, only available on the analog camera.
button. The higher the size, the larger the file it create.
42