Intel Core 2 Duo Processor User Manual page 24

12. From DOS, run the following to reprogram the MAC address and make sure that
there are no warnings or errors:
eeupdate /nic=1 /mac=xxxxxxxxxxxx
•
(xxxxxxxxxxxx is the MAC Address from the sticker)
13. From DOS, run the following to update the keyboard and system controller flash
and make sure that there are no warnings or errors:
kscupdate ksc.bin
•
14. Power the system down by pressing the PWR button.
15. Clear the CMOS by performing the following:
h) Shunt the CMOS CLR jumper (J5H2 – near the on-board battery).
i) Press the PWR button on the board. The board will not power on, but a couple
of LEDs will flash.
j) Switch the power supply off to power down the board.
k) Remove the CMOS CLR jumper (J5H2).
16. Unplug the bootable USB key.
17. Verify correct BIOS installation:
a) Switch the power supply back on.
b) Press the PWR button on the board to power up the system.
c) Boot to the BIOS Configuration screen by pressing F2 at the BIOS splash
screen.
d) In the BIOS main screen, check that the "Project Version" lists the correct
version of the BIOS.
e) Press the PWR key on the board to power the system back down.
18.
The system is now ready for normal operation.
24
Re-connect the SATA data cable from the hard drive to the development
board at connector J6J3.
§
Development Kit User's Manual
Getting Started