Connectors; Back Panel Connectors; Figure 3. Back Panel Connectors; Table 17. Description Of Back Panel Connectors - Intel Core 2 Duo Processor User Manual

4.2

Connectors

Caution: Many of the connectors provide operating voltage (+5V DC and +12V DC, for
example) to devices inside the computer chassis, such as fans and internal peripherals.
Most of these connectors are not over-current protected. Do not use these connectors for
powering devices external to the computer chassis. A fault in the load presented by the
external devices could cause damage to the computer, the interconnecting cable, and the
external devices themselves. This section describes the board's connectors.
4.2.1

Back Panel Connectors

Figure 3

Figure 3. Back Panel Connectors

Table 17. Description of Back Panel Connectors

Item
1 RJ-45 LAN + 2 USB Ports
2 IrDA Transceiver
3 Thermal Diode (no stuff)
4 4 USB Ports
Note: The on-board 14 pin D-Connector J2A1 (#6) supplies the necessary signals to support
the Composite, S-Video, and Component TV standards. Component video and
composite video are connected to the development board using a D-connector to
component video cable (with three RCA receptacles at one end and D-mating
connector on other end) (not included in the kit). S-video is connected to the board
using a D-connector to S-Video cable (with 4-pin DIN connector one end and
D-mating connector on other end) (not included in the kit).
48
shows the back panel connectors on the board.
Description
Development Board Physical Reference
Ref Item
Des
J5A1 VGA (Bottom Side
5 Connector) + Serial Port
(Top Side Connector)
U4A1 6 D-connector
J4A1 PS/2 (Keyboard bottom –
7
Mouse Top)
J3A1
Development Kit User's Manual
Description Ref Des
J2A2
J2A1
J1A1