Hand Held Products Quick Check 200 Series User Manual page 57

Figure 10-6. QCSSP
The power switch is located on the printer's rear panel. It toggles between on and
off. A red light-emitting diode (LED) to the front of the printer indicates the on and
off status. If this light is lit, the printer is turned on. If this light is not lit, the printer
is turned off. If this light flashes, a printer error exists. Refer to Troubleshooting
later in this section for a list of the possible errors.
The Paper Feed button on the front panel has two functions. It feeds paper into
the printer and is used for the printer self-test. The Paper Empty LED lights when
the paper roll is empty.
The printer head lever is located on the front of the printer. This lever raises and
lowers the printer head. You will need to raise the printer head to load paper.
When this lever is raised, the Power LED flashes and the printer will not operate.
You will need to lower the printer head to use the printer.
A panel of DIPswitches is located on the rear of the printer. These switches are
set at the factory for proper operation with the Quick Check.
An interface cable connects the printer directly to the Quick Check to provide
easy exchange of scanning results. The connectors on each end of the cable are
keyed so that they cannot be plugged in the wrong way.
Hand Held Products recommends you use the thermal paper they supply for
correct operation of the QCSSP. The order number is QCTP. Contact Hand Held
Products Customer Administration at the numbers listed on the front cover of the
manual.
51