Hand Held Products Quick Check 200 Series User Manual page 54

4. Unroll several inches of paper from a new roll and cut a straight edge on the
paper if its is jagged or wrinkled. A straight edge helps guide the paper into
the printer.
5. Slide the paper's straight edge into the slot between the paper compartment
and the printer compartment until about one-quarter of an inch is inserted as
shown in Figure 10-5.
6. Press the power switch to the center On positions and wait a few seconds
7. While holding the paper in place, press and hold the power switch in the
Paper Feed (down right) position until an inch of paper emerges from the
printer and then release the switch.
8. Pull the paper through the printer until several inches are exposed.
9. Put the paper spindle into the paper roll and place the roll and spindle onto
the grooves near the back of the printer as shown in Figure 10-5.
10. Roll the paper to take up any slack inside the printer.
11. Ensure the roll turns freely. If the paper roll does not turn freely, the paper
may jam and damage the printer mechanism.
12. Slide the paper's straight edge through the slot in the printer cover.
13. Replace the printer cover by pushing the back of it down into place and
pressing the front down to lock it in place.
48