Remove Ribbon Cartridge From The Qcp Or Qchsp - Hand Held Products Quick Check 200 Series User Manual

Portable and compatible with all major bar code symbologies

Table of Contents

Figure 10-5. Replacing the QCP or QCHSP paper roll

Remove ribbon cartridge from the QCP or QCHSP

Press the printer power switch to the Off (down left) position.

Remove the printer cover by locating the four small grooves embossed on

each side of the printer cover and tilting the cover open by pushing down

gently on both sets of these grooves. The ribbon cartridge should be visible.

Push down on the right side of the ribbon cartridge (marked PUSH) and

remove the cartridge from the printer compartment.

Slide the paper through the gap between the inked ribbon and the frame of

the new ribbon cartridge.

Set the new cartridge into the printer compartment and press both sides to

secure it in place. The cartridge must be properly seated and aligned for the

best print quality. If you get ribbon ink on the printer's plastic case, wipe it off

immediately. Once the ink dries it is difficult to remove.

Replace the printer cover by pushing the back of it down into place and

pressing the front down to lock it in place.

Table of Contents