Save Data When A Printer Is Not Connected; Review Data From The Last Scan; Print Or Delete Stored Data - Hand Held Products Quick Check 200 Series User Manual

Save data when a printer is not connected

1. Scan a bar code symbol.
2. Scan the appropriate special Print/Store Code. The Codes are located at the
back of this manual. There are four codes, one for each type of Quick Check
printer and one for a PC printer. You can save results from up to 25 scans in
this buffer and then connect the printer and print your results.
OR
3. Press Select [0] four times or until Store Data? appears. Press Select [0]
again to store the data. The data is stored in the temporary buffer. You can
save results from up to 25 scans in this buffer. When you connect a printer
and turn it on, you can print the data.

Review data from the last scan:

1. If the Quick Check is turned off, turn it on.
The message, BUF XX% Ful appears.
2. Press Scroll [<>]
The message, Print Bufr? appears.
3. Review the data, press Scroll [<>]
Information from the last bar code scanned appears.

Print or delete stored data:

1. Connect your printer to the Quick Check and turn on both units.
2. Turn on Quick Check.
The message, Buf XX% Ful appears.
3. Press Scroll [<>].
The message, Print Bufr? appears.
4. To print the stored data, press Scroll [<>] twice. After you press Scroll [<>]
once, the message, **Confimr** appears. The Quick Check sends the data
to the printer. After you press Scroll [<>] a second time, the message –
Busy!- appears.
OR
5. To delete the stored data, press Select [0] twice. After you press Select [0]
once, the message, Dump Buffr? appears. After you press Select [0] a
second time, the message, **Confimr** appears.
45