Config." Options - Hand Held Products Quick Check 200 Series User Manual

"Ltr. Grades" vs. "Num. Grades" When the QC200 has been set to an ANSI
grade for its test criteria, the user can have that ANSI grade reported as a letter
or as a number ( 4.0=A, 3.0=B, 2.0=C, 1.0=D and 0.0=F) by selection either "Ltr.
Grades" or "Num. Grades" here.

"Config." Options

After Power up and pressing the Select [0] Button four times, you are brought to
the "Config." Programming Section:
[ - Config. - >]
Pressing the Scroll [<>] Button once at this point will access the area of the
QC200's programming where reporting configuration is determined. Use of the
Select [0] and Scroll[<>] Buttons here will allow you to select the unit's LCD
orientation (Left Handed vs. Right Handed), raise or lower the beeper pitch or
effect volume (Raise Pitch in single steps or Lower Pitch in single steps), select
the Hand Held Products QC printer (HS Printer, VHS Printer or Std Printer) and
finally save the settings in non-volatile RAM for future use. An explanation of
these possible selections follows:
"Left Handed" vs. "Right Handed" The QC200's custom LCD display can have
its text and read-outs oriented for either a left handed or right handed user. This
automatic "flipping" of the LCD image makes the unit easy to use and read by all
operators. Selection of either orientation is done here by pressing the Scroll [<>]
Button.
"Raise Pitch" Repeated pressing of the Scroll[<>] Button increases the
pitch/volume of the QC200 beeper.
"Lower Pitch" Repeated pressing of the Scroll[<>] Button increases the
pitch/volume of the QC200 beeper.
®
"Std Printer" vs. "HS Printer" vs. "VHS Printer" . The Quick Check 200
Series supports all three of Hand Held Products' accessory printers. The QCP,
QCHSP and QCSSP printer interface software is selected here by pressing the
Scroll [<>] Button until the desired setting is shown on the LCD.
To save these settings and the other previous selected options, the user again
presses the Select [0] Button after leaving the desired accessory printer selection
on the LCD. This brings the following message to the LCD:
[SaveSetngs?>]
Pressing the Select [0] Button will by-pass this (effectively answering "NO"), but
pressing the Scroll [<>] Button will accept it, changing the LCD to:
19