Guard Support Shaft; Installing New Blades; Motor Bracket - Grizzly G5959 Instruction Manual

4. Attach the square fence tube to the front rail
using the hex bolts and lock washers as
shown in Figure 10A.
5. Attach the fence and slide across the length
of the rails to ensure smooth, accurate fence
movement.
Figure 10A. Attaching fence tube to front rail.

Guard Support Shaft

To install the guard support shaft:
1. Push the threaded end of the shaft through
the hole in the back of the saw (Figure 10B)
until the shoulder on the shaft stops it.
2. Secure with the hex nut and washer.
FIGURE 10B. Attaching guard support shaft.
G5959/G9957 12" Table Saw
Installing Saw Blade
The saw blade is extremely sharp. Use extra
care when handling the blade or working
near it. Serious injury is possible.
Please review this section even if your saw blade
came pre-installed. To install the blade:
1. Remove the table insert to gain access to the
arbor.
2. Remove the nut and outer arbor flange from
the arbor.
3. Place the blade on the arbor, making sure
that it seats firmly against the inner arbor
flange. Ensure that the top blade teeth are
facing the front of the saw.
4. Replace the outer arbor flange and rethread
the arbor nut.
5. Hand tighten the nut and snug with the arbor
wrench included with the saw. DO NOT
overtighten.
IMPORTANT: Make sure the blade is installed
with the teeth facing the front of the saw.

Motor Bracket

Remove Before Operating Saw
Figure 11. Remove motor bracket.
G5959 and G9957 12" Table Saw