Vertical Assembly - Grizzly G0561 Owner's Manual

Vertical Assembly

The Model G0561 can easily be set up for vertical
cutting operations.
Components and Hardware Needed:
Vertical Work Table ............................................1
Table Bracket .....................................................1
Flat Head Screw ⁄ "-20 x
1
4
Hex Nut ⁄ "-20 ................................................... 1
1
4
To assemble the bandsaw for vertical cut-
ting:
1. Remove the two screws and blade guide
cover as shown in Figure 15.
Figure 15. Removing blade guide cover.
2.
Install the vertical work table and replace the
two screws removed in Step 1.
3. Install the table bracket shown in Figure 16
with the bolt already in the casting.
Bolt Already
in Casting
Figure 16. Table and bracket installed.
-20-
Qty
⁄ " ............................. 1
3
8
4.
Set a square to the side of the blade, as
shown in Figure 17, and adjust the table
bracket to square the table to the blade.
Figure 17. Squaring table to blade.
5. Place a level on the table, as shown in Figure
18, and turn the adjustment bolt shown in
Figure 19 until the table is level.
Figure 18. Adjusting table level.
Figure 19. Adjustment bolt.
6.
Close the feed ON/OFF valve to lock the bow
in position (see Figure 20).
G0561 7" x 12" Metal-Cutting Bandsaw